Skip to main content

How to change the wax filter with CeruStop on Phonak hearing aids

Replacing the wax filter with CeruStop on Phonak RIC (Receiver-In-Canal) hearing aids with a dome earpiece.
To replace the earwax protector on the receiver, only use the wax filter tool that was recommended by your hearing care professional.

  1. Remove the earpiece from the speaker by holding the speaker in one hand and the earpiece in the other.  

  2. Gently pull off the earpiece to remove.  
    A drawing of a hand holding a wire  Description automatically generated 

  3. Insert the removal side of the exchange tool into the used earwax protector. The shaft of the holder should touch the rim of the earwax protector. 
    A drawing of a couple of hands holding a pen  Description automatically generated 

  4. Carefully pull and remove the earwax protector straight out of the speaker. Do not twist the earwax protector when removing. 
    A drawing of a device connecting to a device  Description automatically generated 

  5. Clean the speaker with a lint-free cloth. 

  6. To insert the new earwax protector, gently push the insertion side of the exchange tool straight into the hole of the speaker until the outer ring is perfectly aligned.
    A drawing of a pen and a green arrow pointing at it  Description automatically generated 

  7. Pull the tool straight out. The new earwax protector will remain in place.

    A drawing of a device  Description automatically generated with medium confidence 

  8. Now attach your earpiece to the speaker. 
    A drawing of a hand holding a small piece of wire  Description automatically generated